FMC100SM20KSC 100M FIBRE MEDIA CONVERTER

10/ 100M Fibre Media Converter translates the signal froma twist-pair 10/100Base-TX cable to 100Base-FX fibre optic cable, extends data transmission distance from 100m via copper cables to 20km by fibre optic cable, which supports LFP (Link Fault Pass-through) function & USB Powered.

Features

• 10/ 100Mbps auto-sensed, easily upgrade
• Full-duplex and half-duplex auto-sensed
• MDI/ MDI-X Auto Negotiation
• 10/ 100Mbps store-and-forward
• 100Mbps cut-through transmission
• Packet size up to 1518bytes
• Supporting VLAN/ VoIP/QoS packets
• Support flow control and reduce broadcast packets
• Supporting STP to form a redundant network
• Extremely low power consumption, low heat and stable performance
• Providing Desktop, Wall-mounted, Chassis and DIN-rail installation
• LFP (Link Fault Pass-through) Function
• External Power Adapter or USB power source
• DIP Switch to set configurations
• Supporting extra-long packets up to 1600 bytes

Applications

• Network Communication
• FTTH/ FTTB/ FTTx
• ISP Backhaul Networking

Available Fibre Media Converters

{tab Specifications}

What are the DIP switches on the side used for?

Switch 1 - The default setting is (AUTO), which is maximum speed and diagnostic features (LFP)on. This is recommended for normal operation. Force is used when trouble shooting or for special applications.

Switch 2 - Allows user to select a smaller bandwidth (10mpbs or 10BASE-T).

Switch 3 - Fiber has a Send (Tx) and Receive (Rx) channel. When both are enabled, you have FDX orFull Duplex. Some add-on modules are only capable of sendingor receiving and not both. This is called half-duplex (HDX).You can override the FDX using this switch. Switch3 addresses the ethernet ports.

Switch 4 - LFPT will indicate if a fault is present. Without LFPT you may not be aware of an issue. It's suggested to leave LFPT on, but when trouble shooting, LFPT can be set to off.

Switch 5 - Half or full duplex settings for the fiber ports.