Can't find what you're after? Use the Support link on the bottom right or give our expert team a call on (03) 9321 8300
Search our range of quality products...
Can't find what you're after? Live Chat or give our expert team a call on 1800 337 366

PA AMP ACCESSORIES

True 1
RMA16 volume control. 100 Volt line 6x 100 Watts Off position 10 Volume steps
$625.00
Special
Buy-In
View Product Increase value Decrease value
True 1
Insert into a WT482 or add wireless capabilities to your WA1822. Diversity Tuner Module F01:636-666MHz Frequency Range
$459.00 TRADE ALERT!
Special
Buy-In
View Product Increase value Decrease value
True 2
Rack Bracket Kit for single unit
$39.00 TRADE ALERT!
Special
Buy-In
View Product Increase value Decrease value
True 1
Rack mount brackets for Show MPA/MA Series 2RU Amplifiers.
$15.00 TRADE ALERT!
In Stock
Increase value Decrease value
True 1
The AN-001T is a 2ch plug-in ambient noise detector for use in the 9000 series amplifiers Automatically adjusts gain to compensate for changes in ambient noise level Each input can be assigned to control a specific output 24VDC phantom power for condenser mics 14 preset gain ratios
$569.00 TRADE ALERT!
Out of Stock!
Increase value Decrease value
True 1
Rack Mounting Brackets for A9II, A2, A17, A18 series Amps (2RU).
$29.00 TRADE ALERT!
Low Stock
Increase value Decrease value
True 1
Screw terminals for 100V input 3-Pin XLR mic socket 2x RCA auxiliary socket Requires no power
$126.50
Low Stock
Increase value Decrease value
True 2
The Zoned Out is a simple way to have up to 6 zone output zone switching in your installation. 100 Volt output switcher 6 Zone outs
$120.00
Low Stock
Increase value Decrease value
True 1
The JUICED UP is a 2 channel phantom power supply that features balanced XLR inputs and outputs per channel. Operates via the supplied external power supply or two on-board 9 Volt batteries Will supply 12V DC phantom power from battery power and 42V DC phantom power from an external power supply
$160.00
Low Stock
Increase value Decrease value
True 2
Compact yet highly featured microphone pre amplifier. 40VDC phantom power Microphone/Line Pre amp Switchable High Pass Filter Balanced XLR output
$160.00
Special
Buy-In
View Product Increase value Decrease value
True 2
The LETS SPLIT (M) is a balanced microphone level splitter with a balanced XLR microphone level input which provides both a transformer balanced XLR output and a thru (direct) XLR output of the input signal. Provides a ground lift switch to eliminate ground loop hum. Microphone level splitter Direct and transformer balanced outs
$140.00
Special
Buy-In
View Product Increase value Decrease value
True 4
FBQ feedback detection system Balanced Inputs and Outputs Ultra low noise Op Amp Shielded Toroidal power transformer
$225.00
Special
Buy-In
View Product Increase value Decrease value
True 1
Put simply, the MTR15 converts your amplifier's speaker output to a 1V line. Low impedance outputs Cabling is expensive for most mid-range jobs Output is in stereo Massive cable runs (100 metres)
$149.00
DON'T PAY $199
Low Stock
Increase value Decrease value
True 1
"Hum" noise is a common problem in sound systems, even with the volume control set at minimum level. The HEB-100 is a low-cost tool that you can use to prevent the "hum" caused by ground loop. This unit can also act as a converter of unbalanced signals.
$99.00 TRADE ALERT!
Low Stock
Increase value Decrease value
True 2
3 pin female XLR to unbalanced 1K Ohm 2 x RCA with level control.
$43.50
In Stock
Increase value Decrease value
True 2
Unbalanced 10K Ohm2 x RCA to balanced 600 Ohm 3 pin male XLR with level control. -10dB max signal gain.
$39.95
Low Stock
Increase value Decrease value
True 3
The MQS75 converts consumer level stereo RCA signals to balanced XLR professional line level, and back. It is the ideal solution for connecting audio sources like CD players, camcorders etc to professional devices like mixing boards, signal processors and associated amplifiers. Acts as a balanced XLR line level control Individual volume level controls for line 1 and 2 RCA to XLR and XLR to RCA conversion
$109.00 TRADE ALERT!
In Stock
Increase value Decrease value
True 2
For running two mixers from the one microphone ? for example broadcast and PA. Input impedance: 600andOmega; Output impedance: 600andOmega; Dimension: 95x73x40mm Weight: 305.5g
$49.90 TRADE ALERT!
In Stock
Increase value Decrease value
True 2
Australian Monitor Buzz Off contractor tool. Two channel Balanced (XLR) and unbalanced (RCA) ins & outs
$170.00
Special
Buy-In
2 IN STOCK
View Product Increase value Decrease value
True 2
Change mic level to line level
$140.00
Low Stock
Increase value Decrease value
True 2
For when you need to connect a low-impedance or condenser microphone to a high-impedance mixer input, a PC sound card, a powered speaker or possibly an instrument amp. Input Impedance: 10kandOmega; THD: <0.01% IMD: <0.01% Output gain: 50dB (XLR), 44dB (6.3mm)
$99.00 TRADE ALERT!
In Stock
Increase value Decrease value
True 2
The MQS52 features a full selection of standard pro audio connectors for testing the five basic types of cables used widely in pro audio. Jacks: XLR, Phone Jack, Stereo RCA, DIN Dimension: 113x73x40mm Weight: 367.5g
$39.00
DON'T PAY $49
In Stock
Increase value Decrease value
True 3
Stereo Line RCA input and output Easy operation for Audio players, powered speakers or amplifiers Infrared remote control in tiny size Adjust Volume level and mute on/off
$89.00
In Stock
Increase value Decrease value
True 1
2-Channel signal outputs Signal noise eliminator Adjustable output level Auto remote amplifier turn-on
$35.00
DON'T PAY $49.95
TRADE ALERT!
Low Stock
Increase value Decrease value

Be the first to hear about it!